Posts Tagged ‘ABS’

First BuildTak experience

Earlier in the week whilst trying out printing ABS on my 3D Printer I found that I was getting warping issues using the blue painters tape that I’ve always applied to my print bed.  I’ve been reading up about different printing surfaces, and ended up settling upon BuildTak since I’ve read some really good things about […]

By continuing to use the site, you agree to the use of cookies. more information

This website uses cookies to enhance your browsing experience, and as such the cookie settings on this website are set to "allow cookies". If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.